Vermis Definition

<meta name="title" content="Vermis Definition"/>

Cerebellum Protocol Project
Whole Cerebellum	Lobe Definitions	Vermis Definition	Lobule Delineation

General Delineation of Vermis

The vermis is the region of the cerebellum separating the two hemispheres, and therefore lies in the mid-sagittal slices. Once the vermis has been located, the left and right hemispheres are relatively easy to locate and label.

The vermis can be located in several ways:

1. The vermal region of Lobule IX is nicely separate from the hemispheres and therefore can be located relatively easily (see the Lobule Identification section on Lobule IX vermis).

• In the Schmahmann book, IX_v exists (approximately) between sagittal slices X=-6 and X=+6

2. The vermis is also located by the following:

• The corpus medullare is much thinner in the vermis than in either hemisphere
• It is located in the sagittal slices near the connection of the cerebellum to the brain stem.
• Check axial and coronal views for the paravermian sulcus (see below)

3. Lobule I/II exists only in the vermal region, and therefore, any sagittal slices that contain this lobule can be considered part of the vermis

• The problem with this is that Lobule I/II is difficult to locate, and therefore finding a precise boundary of the lobule, and thereby the vermis is difficult

To best take advantage of #1, Lobule IX should be labeled first to help in locating the vermis and delineating the hemispheres and vermis (it is also easy to identify). Once IX_v has been delineated, most lobules in the same saggital slices should also carry the ‘_v’ label. However, care must be taken with the tonsils, and with lobules that span the paravermian sulcus (see below).

With the vermis located, the hemispheres can be delineated. Note that the left and right hemisphere labels should correspond the patient’s left and right.

It is therefore important to note the radiological convention – MRI images are usually oriented as though one is looking from the feet up the patient up towards the head. In this case, when viewing an axial or coronal images, the patient’s left is on the right side of the image, and vice versa. Make sure you are aware of the convention being used. To check the convention in MIPAV: Image -> Attributes -> View Header

Paravermian Sulcus

---

The paravermian sulcus is marked by the crosshairs in the figure below. It marks the separation of the hemispheres at the rear of the cerebellum.

The orange region in the figure below shows a previously labeled lobule IX_v. The green rectangles show the regions of the cerebellum that should be included in vermis labels. The red rectangles show regions that should NOT be included.

1. The tonsils should not be included in the vermal region (they belong to IX_L and IX_R). This is indicated by the upper (anterior) red rectangle in the axial image and the lower (inferior) red rectangle in the coronal image. 2. Furthermore, parts of the cerebellum that are on the edges of the paravermian sulcus should not be included in the vermal region. This is indicated by the lower (posterior) red rectangle on the axial image.

Caudal Lobules - Vermis (VIII-X)

The Vermis for the Caudal Lobules is most easily delineated, and should therefore be identified first. The axial view is usually the best perspective from which to delineate. Often Lobule IX vermis is easily located between the tonsils (which should NOT be included in the vermis).

• Axial View
  • Lobule X's vermis is the anterior most portion of the vermis and appears as a round shape appearing in the same slices as the Fourth Ventricle.
  • Just Posterior of Xv is IXv, which is triangular, resembling an arrowhead.
  • Posterior of IX v is VIIIAv and VIIIBv which look like an up-turned arches.

• Coronal View
  • The portion of the vermis between the tonsils looks like a downward pointing triangle.
  • Other (more posterior) portions appear round, with arching white matter.

• Sagittal View
  • Provides little to no information.

The Middle and Caudal Vermis

• 
• 
• 
• 

• 
• 
• 

Middle Lobules - Vermis (VI-VII)

• UNDER CONSTRUCTION

Axial View of Lobule VI Vermis

The inferior most lobules in this lobe (VIIB, VIIACrusI have vermian regions resembling those of VIIIA and VIIIB). These should be delineated first. Note that VIIIACrusII does NOT have a vermian region.

• Axial View
  • VIIB and VIIACrusI look like an up-turned arches.
  • VI may have a rounded portion (see Figure)

• Coronal View

• Sagittal View
  • Provides little to no information.

Anterior Lobe Vermis (I-V)

The Anterior Vermis - Ext

• UNDER CONSTRUCTION
  

The Anterior vermis is very narrow with only subtle clues as to its boundary with the hemispheres. Great care should be taken in its delineation.

• Axial View
  • Look for and include small rounded structures near the mid-sagittal plane of the cerebellum. These look like "Ice cream scoops"

• Coronal View
  • Look for white matter branching inward and outward and merging near the midline of the cerebellum.
  • The vermis exists between these branches and is at its widest near the mergers (see Figure).
  • Do NOT include vertically oriented white matter. Horizontal white matter may be included.

• Sagittal View
  • Provides little to no information.

• 

  The Anterior Vermis - Ice Cream Scoops

• 

  The Anterior Vermis - Fingers

Cerebellar Hemispheres

Once the vermis has been delineated, the hemispheres should be given separate labels as follows:

1. Lock the all vermis labels.
2. Lock all hemisphere labels except for the anterior lobe.
3. Paint the left hemisphere (right side of the image - CHECK HEADER!).
4. Repeat for the caudal and middle lobes.

• NOTE: Use the following labels for this step:

Label Number	Structure
1	Anterior Right
2	Corpus Med
3	Caudal Right
4	Middle Right
5	Anterior Vermis
6	Caudal Vermis
7	Middle Vermis
8	Anterior Left
9	Caudal Left
10	Middle Left